NAC Image Technology ST-839, User Manual

Page: 30 / 370

Camera Installation
Camera Installation
The MEMRECAM HX-7 can be setup on a level table or tripod.
2-2
(00400)
■ Camera Installation on a Level Table
The Memrecam HX-7 can be setup on a level table or desk.
There are intake ports and exhaust vents on the front, back, left and right sides of the camera
for ventilation using the fan.
To avoid hampering the air flow, install away from walls. If possible, install in a location with
good ventilation.
Make sure not to obstruct or cover the intake ports or exhaust vents.
■ Connecting the Memrecam HX-7 to a Tripod
The Memrecam HX-7 requires two 3/8-16UNC diameter screws less than 7mm in length for mounting to a
Tripod.

The weight of this device alone is approximately 2.7kg or 5.95lbs. not including the handle and
lens mount. Use a tripod rated for this weight including the lens and cabling.

Contact your Sales Representative for the recommended tripod.
Mounting screws (Depth 7mm)