32 of 43
GT20 Wire and Programming Manual
www.NabcoEntrances.com
P/N C-00140
Rev 5-7-18
Table 16
REINIT Menu: Reverts Settings back to Factory Default
Element
Description
FACTORY RESET
All settings that were programmed into the Control will be reset to Factory Defaults.
PARAM RESET
Resets/Sets all motion Parameters back to the default values (inclusive opening angle, rod assemblies,
Invers and dAxix).
CONFIG RESET
Resets all configuration settings back to the default values.
DOUBLE RESET
Resets simultaneous pair settings and airlock settings back to the default values.
Table 17
Block/Unblock Menu: Lock Keys
Menu
Description
Block?
To lock the Joystick
Press OK for 2 seconds
The Display shows temporarily
BLOCK!
UBLOC?
To unlock the Joystick
Press OK for 2 seconds
The Display shows temporarily
UBLOC!
BlockD
When the Joystick is blocked, the "Home display" shows
BLOCKD
, if the Joystick is operated!
Table 18
Update SoftWare
Element
Description
Update SW
Updates the latest version of software.
Table 19
Teach Menu
Element
Description
TEACH OK?
Programs the Setup Procedure within the GT20 Control.
CHAPTER 10: DOUBLE SWING DOORS
DN 1183
Master Door Panel:
Opens fi rst; Closes second
Slave Door Panel:
Opens second; Closes fi rst
Master Operator Assembly
Slave Operator Assembly
Figure 5
Open, Close sequence Order
SECTION 10 .1: Activation Input Connections:
Activation Inputs:
X
(KE) Night Mode
X
(OEO) Exterior Activation Sensor
X
(OEI) Interior Activation Sensor
Connected to the:
X
Master Door Panel: Will open the Master door only.
X
Slave Door Panel: Will force the Master Door Panel to open first and then the Slave Door Panel second.
