Rev. 9-24-14
Part #15-10683
GT 710-8710 Swing Door System Low Energy Operator
Getting Started
2-5
CHAPTER 2: GETTING STARTED
Section 2a:
Electrical Standards
Note: It is recommended for the Installer to use an Electrical Conduit to house all incoming 120 VAC wires.
Note: All wiring must conform to standard wiring practices and be in accordance with national and local
electrical codes.
Electricity
Description
Power Input
120 (±10%) AC 50-60Hz, 10 Amps
Available Current for Accessories
0.5 Amps 24 VAC
Available wire size for incoming power
14 AWG
Section 2b: Installation Specifications
Specification
Measurement
Minimum Frame Face for Mounting
1-3/4 inches (44mm)
Minimum Clearance from Top of Door to Ceiling
7” (178 mm)
Door Hinge Requirements
3/4 inch Butt, Offset Pivot, or Center Pivot
Minimum Door Thickness
1-3/4 inches (44 mm)
Door Width
Specified when ordered
Section 2c: Base Unit Type
X
Side Load Header only.
X
Low Energy Swing doors utilize a Knowing Act to open a Swing door.
• A conscious effort that is carried out in many different ways, including (but not limited to):
manually opening/closing a Swing door; pressing various types of Push Plates; turning a
Key switch; flipping a Rocker Switch; utilizing a keypad or card reader, etc.
X
Must be compliant with the ANSI Standard Code 156.19 to reduce chance of injury to
pedestrians and wheeled traffic.
Always remove the bottom portion of the HandiCap Label stating “Push Door To
Operate” if the “Push-n-Go” feature is not being used.
DN 1108
PUSH DOOR
TO OPERATE
NABCO Entrances, Inc. p/n 148701
AUTOMATIC DOOR
Figure 2-1
Cut Bottom Portion of HandiCap Label when Push-n-Go Feature is not used
DANGER
