7 of 26
www.NabcoEntrances.com
GT1400StandardSingle/HurricaneSingleFoldingDoorInstallationManual
Rev 6-14-21
P/N C-00177
Figure 5
Orientate Frame to Breakout Side of Rough Opening
DN 0989
Magne c Latch
Bo om of Jamb Tube
(towards Exterior opening)
EXTERIOR
Door Opening
Weathering must face up
(towards Exterior opening)
3. Lift to position the assembled Frame into the rough opening.
4. Plumb Jamb tubes in both planes to ensure the rough opening allows a 1/4 inch clearance. Shim back of Jamb as required.
5. Plumb the Header at the top to ensure the rough opening allows a 1/4 inch clearance. Shim top of Header as required.
6. Secure Jamb Tubes to Rough Opening accordingly.
X
Standard Fold Door
•
Use 1/4 inch diameter anchors with a minimum of 3 per Jamb tube, maximum is 48 inches on center. Drill 1/4 inch
diameter holes in the face of Jamb and then countersink each hole. Secure with appropriate Fasteners.
X
Hurricane Fold Door
•
Screw in anchors to secure the Frame (per manufacturer’s certification document(s).
Section 5 .3 Secure Header to Rough Opening
Verify that each Motor is connected to the Opus Control before inserting Pin or 1/8” Allen
Wrench into Coupling Access Hole via the Access Hole on the Opus Control. Failure to do so
will allow the Fold Doors to slam shut without motor braking in the event the Pin or 1/8” Allen
Wrench falls out.
Do not let go of the Guide Channel if a Pin or 1/8” Allen Wrench has not been inserted into the
Coupling Access Hole, it will spring back to its original location and can result in personal
injury or damage.
1. Ensure the Motor is connected to the Opus Control.
2. Swing the Guide Channel out and away from the Magnetic Latch. It will be necessary to manually hold the Guide Channel in
the 90 degree position until the Pin or 1/8 inch Allen Wrench is inserted into the Coupling Access Hole.
Figure 6
Swing out Channel Guides
DN 0990
Guide Channel
(open towards Exterior)
Swing Out
90
EXTERIOR
1/4" Anchor
3. Locate the access hole in the Opus Control mounting bracket which leads to the Coupling Access Hole in the Operator. Insert
a Pin or 1/8 inch Allen Wrench into both Access Holes.
DANGER
DANGER
