Nabco C-00139, Installation Manual

Page: 7 / 32

7 of 32
www.NabcoEntrances.com SwingandFoldDoorOpusControlWiringandProgrammingInstallationManual
Rev. 8-11-21 P/N C-00139
X
Turn the Rotary Dial (2) clicks to advance through each menu item:
• Clockwise: To scroll forward through screens and programming options .
• Counterclockwise: To scroll backward through screens and programming options .
SECTION 3.8: IO Terminal strips
I/O Terminal Strips (1 thru 14)
1 12VDC +12VDC 8 BA Breakout
2 GND Common for 12V and signals 9 SQ Sequential activation (signal to open, signal to close)
3 61 Interior Activation 10 H Reduced Open (Programmable Input)
4 62 Exterior Activation/Programmable Input 11 M0 Mode 0 One way when
connected to Common
Hold Open when
both M0 and M1
connected to
Common
5 6B Continuous Safety
6 SWL Default setting: Safety with Lockout 12 M1 Mode 1 Night when connected
to Common
Rev 27 & Later: Input is programmable
7 Out1 Sensor Monitoring (Programmable Output) 13 Out 2 Aux. Output 2, Programmable output, closes to GND
Closes to Common 14 GND Common for all above signals
SECTION 3.9: Relay Output Terminal Strip
Relay Output 3
COM
Common
N.C.
Normally Closed Contact
N.O.
Normally Open contact for Sensor Monitoring
SECTION 3.10: CAN Bus Communication
Used to connect Sim Pair, Astragal, Sequencing and the NET-HT Cable when programming.
CHAPTER 4: LCD CATEGORY SCREENS
Passcode
Go to Se ng Menu
Stroke Learning
Yes No
UNIT SPECS ERROR ANSI TERMINAL
Long
Push
LEVEL 1
LEVEL 2
Rotate Dial to navigate screen. Short Push Dial to select
Se ng Category
LEVEL 3
Parameter Op ons
Base Se ng Operator Type/Low or Full Energy/Handing/Encoder
Movement Se ng
(Rotate Rotary Dial)
Open Speed/Back Check Speed/Back Check Range/Close Speed/Latch Check Speed/
Latch Check Range/Open Timer/Reac‹ on Power/Open Recycle Sens/Close Recycle Sens/
AΠer Open Recycle
Op‹ onal Se ng Hold Close Force/Power Close Range/Manual Open Func‹ on/Manual Open Sens/Manual
Open Timer/BCHK Lockout Angle/LCHK Lockout Angle/Stop Force adjustment/SimPair Se ng
Output Se ng Output1 Se ng/Output2 Se ng/RelayOutput3 Se ng/Open Delay Timer/
Sequence Delay Timer/Lock Condi‹ on
Input Se ng Input 62 Se ng/Input 62 Open Timer/Input H Se ng/Input H Open Timer/Input 61 Circuit/
Input 62 Circuit/Input 6B Circuit/Input SWL Circuit/Input BA Circuit/6B Stop Closing/AΠer 6B
Open?/61 Monitoring/62 Monitoring/6B Monitoring/SWL Monitoring
History Data Opera‹ on Cnt/Open Recycle Cnt/Close Recycle Cnt/Latest Recycle Posi‹ on
DN 1334
LEVEL 4
Push and Hold Rotary Dial (2 Sec.)
Rotate
Dial
Rotate
Dial
Rotate
Dial
Short
Push
Figure 2
LCD Screen Transition