E N G LI S H F R A N Ç A I S
CONNEC T THE 3 - PIECE POWER CORD TO
THE TABLET
1. Pull down and remove the blue plastic plug
from the elbow of the mounting arm.
2. Find the top end of the internal power cord
showing through the top of the Handlebar
Post (under the handlebars). Thread the cord
through the hollow mounting arm from the
bottom and through the hole at the bend in
the arm.
3. Pull the wire through the elbow hole and
connect it to the tablet, allowing 8-10
"
of
slack so the tablet can swivel freely. Replace
the plastic plug In the elbow.
4. Connect the male end of the power brick
(transformer with 6' cord) into the female
plug-in below the flywheel (center of front
stabilizer base).
5. Plug one end of the wall cord (6 ft cord)
into the power brick and the other end to a
grounded 120V wall outlet.
Power Brick Plugs in here.
Connect one end of the
wall cord to the Power
Brick and the other end
into grounded wall outlet.
Cord and Power Brick
are in the Tablet Box
2
3
4
5
1
