MyTana ST LineFinder User Manual Download Page 1

Important!!

WARNING! Failure to follow these 

warnings could result in serious injury or 

death.
• Only persons qualified and trained  

to operate cable & pipe locators  

may operate this equipment.

• Follow appropriate safety procedure, 

your companies policies and applicable 

safety codes and/or laws.

• Do not connect to utilities, cables or 

pipes without authorization and training. 

Use tool only for intended purpose as 

described in this manual

• Do not expose tool to rain or moisture.
• Do not expose to hazardous chemicals, 

hazardous gas or explosive environment.

• SHOCK HAZARD - Lethal voltages may 

be present at the transmitter’s output. 

Turn off transmitter before touching 

test lead or any un-insulated conductor. 

Make connection to ground and target 

conductor before turning on transmitter.

• SHOCK HAZARD Do not connect to  

live voltage or active utility lines. De-en-

ergize any circuits in or around  

the work area.

• This tool is designed to detect electro-

magnetic field emitted from cables and 

buried metallic utilities.

• There are buried cables, pipes, and utili-

ties this instrument CANNOT detect.

• LOCATING is not an exact science. 

The only certain way to be sure of the 

existence, location, or depth of buried 

utilities is to carefully expose (dig up)  

the utility.

DISCLAIMER OF LIABILITY
MYTANA LLC SHALL NOT BE LIABLE TO 

ANY PERSON FOR ANY INCIDENTAL, 

INDIRECT, SPECIAL, EXEMPLARY OR 

CONSEQUENTIAL DAMAGES, OR INJURY 

OF ANY TYPE WHATSOEVER, CAUSED 

DIRECTLY OR INDIRECTLY BY PRODUCTS 

SOLD OR SUPPLIED BY MYTANA LLC.

090821

Please inspect all parts  

carefully upon receipt.

Make sure there is no shipping 
damage and all the parts are 
included:
•  ST LineFinder Transmitter
•  Direct connection cable
•  Grounding rod
•  Battery recharging cable  

(lithium-ion battery  

is already installed)

•  Carry bag

Introduction 

The ST LineFinder Transmitter is capable of 
detecting buried power cables, CATV cables, 
gas and water pipes, sewer lines, telephone 
cables, fiber optic cables with sheath. 

The transmitter emits a signal that is 
conducted by, or coupled to a conductor (the 
buried utiltity). A receiver (such as our ST 512+ 
Locator) detects the signal. You can locate the 
relative position of the buried conductor by 
following the tracing signal.

Manufacturers of Quality 
Sewer & Drain Cleaning 
Equipment since 1957

(800) 328-8170 

Factory Direct Customer Service

M –F    7am – 5pm CST 
Competent • Polite • Clear 

www.MyTana.com

746 Selby Ave  •  St. Paul, MN 55104 

fax:  (651) 222-1739

ST LineFinder Transmitter  

User Manual 

Summary of Contents for ST LineFinder









Reviews: