AC ELWA
®
Installation and Operating, Version 1.0, Date 2016-01-23
9
PLA Settings
1x: Setup mode
6x: Charge
6x: Charge
1x: Setup mode
Normal mode
Normal mode
Reheat on
Stratification
Synchron
Reheat off
2x: Setup time
2x: Setup time
2x: Setup time
0x:
time
0
_:__
1x: 1
time
_:__
2x: 2
time
_:__
3x: Setup time
3x: Setup time
0x: 0
time
1 :__
9x:
time
1 :__
9
4x: Setup time
4x: Setup time
short keystroke
1 s keystroke
1 s keystroke
5 s keystroke
LED on
LED flashes
5 s keystroke
0x:
00 time
10:
3x:
45 time
10:
1
1x: 15
2
2x: 30
3
4 5
6 7
8
The value for backup heating or stratification / synchronous charge is stored with 1 second keystroke
permanently. Menus are automatically exited without saving if key is not pressed for 30 seconds.
Reheating:
In the first menu item reheating can be enabled. This function is for automatic hot water ensuring. This allows
you to switch off the heating system used normally to heat water. Reheating is useful in non-heating period.
If reheating is on, all connected AC ELWAs which have an adjusted reheating temperature will be activated
from 16:00-23:00, regardless of whether or not excess power is available. The AC ELWAs then heat to each
setpoint.
Time of day
The time setting is relevant to the reheating. The accuracy of time is 15 minutes.
Note: time is not maintained during a power failure!
Stratification and synchronous charge:
x
The PLA can control the AC ELWAs with different priorities:
In stratification mode, the AC ELWAs will be driven to their rated power in order (according to their
number, smallest first).
x
In synchronous mode all connected ELWAs are controlled with the same power.
