Mylex Disk Array controller Software Kit 2.01, Installation Manual And User'S Manual

Page: 50 / 172

Mylex Disk Array Controller Drivers for Windows NT 4.0
3-2 Disk Array Controller Software Kit User’s Manual
Mylex Disk Array Controller Drivers for
Windows NT 4.0
Installing the Mylex Disk Array Controller as the Primary
Windows NT 4.0 Controller
If the Mylex Disk Array Controller will be the primary (bootable) controller,
you must install the controller driver at the time of Windows NT 4.0
installation.
Before proceeding you should have already carried out the following steps:
• Installed the Mylex Disk Array Controller hardware, connected the
disk drives to the controller and to each other, set drive SCSI IDs, and
terminated the SCSI bus following the instructions in your Mylex Disk
Array Controller hardware installation guide.
• Use the Mylex Disk Array Controller Configuration Utility to create a
drive configuration and initialize the drives for use following the
instructions in your Mylex Disk Array Controller Configuration Utility
manual.
To install the controller driver during Windows NT 4.0 installation:
1. Boot the system with the Windows NT 4.0 setup diskette #1.
2. Insert setup diskette #2 when prompted and press <Enter>.
3. Press <Enter> again when prompted.
4. Select Custom Setup in the Windows NT Setup screen.
5. Next, choose S to skip the automatic detection scan.
6. Choose S to specify an additional device.
7. Choose Other in the list of supported adapters displayed and press
<Enter>.
8. When prompted for the Manufacturer’s supplied hardware support
disk, insert your NT/NW Drivers Software Kit diskette into the floppy
disk drive and press <Enter>.
9. Select the Mylex Disk Array Controller Driver in the list and press
<Enter>.
10. Choose S to specify an additional device.