Preparations
▍
Setting up MYIRO-9
The MYIRO-9 should be set up on a flat, level surface with sufficient space for color charts in front of and behind the MYIRO-9. There
should be enough space in front of the MYIRO-9 for color charts to be measured to be inserted into and ejected from the MYIRO-9 without
any obstacles, and enough space behind the MYIRO-9 for color charts to fully extend from the MYIRO-9 without obstacles. (See below.)
• If the MYIRO-9 is set up on a rough surface or a surface which is not level, measurement accuracy may suffer.
• Obstacles may cause the color chart to bend or be shifted to either side, resulting in damage to the color chart or misalignment during
scanning.
• After scanning, the scanned color chart will be ejected from the front of the MYIRO-9. If the MYIRO-9 is placed at the edge of a table,
the ejected color chart might fall to the floor and be damaged.
Necessary space
Maximum chart
paper length
Maximum chart
paper length
14
