The MyGate Q71S Control Board Installation Manual : Printed 11/02/2013 13:16
13
Changing the key-fob battery
When the capacity of this battery runs low, you may see the LED transmitting indicator on the key fob lit
faint and the control board may not respond to your command as the signal may be too weak. To change
the battery, follow the next set of steps:
1) Turn the key-fob over so it is resting on its front. To the bottom
of the key fob you will see a compartment cover. Using a small
flathead screwdriver, insert this between the casing and the
battery compartment cover to gently release the cover.
2) Obtain size 23A 12V battery from Gate Motors and replace
like for like. Once the battery is in place replace the compartment
cover.
Changing the code the key-fob transmits
Upon use of the key-fob, if you find that the code the key-fob transmits is not being identified by the control
board, is intermittent in receiving the signal produced or someone else in the immediate area is using (RF)
radio equipment that is transmitting a similar code on the same frequency, you can change the
rolling
code
that the key-fob transmits. This is achieved by following the next set of steps:
Simultaneously press buttons B and C (about 4-5 seconds) till the
red light of the remote control illuminates.
Hold button B pressed and at the same time release button C and
press it again twice.
The two lights, red and green, should alternating blink to show that
the generation of a new random code succeeded.
Now you can release button B. The remote control is ready to
transmit with a new radio code.
N.B.
– Please delete the previous
stored key fob from the control board
Once this has been completed you must program the key-fob to the control board so it can recognise the
new code generated.
