The Cadence
Assembly Instructions
Step 1
Thank you for choosing Mycle and we’re thrilled to have you join our community of
myclists. Your Cadence comes pre-built, but there is a small amount of assembly
required to get it ready to ride. When you’ve unboxed your bike and removed all
packaging, read on for your full assembly and quick start instructions.
If you have any questions, you can reach out to our friendly customer care team on
01295 231105
Inserting the front wheel
The Cadence comes with a quick release front
wheel, which makes it easy to put on and take off
without tools.
The quick release skewer is already in the centre
of the front wheel. Simply open the lever and
rotate anticlockwise to extend the skewer until
there is sufficient space for the forks to fit either
side of the wheel and springs.
Your front wheel can only go in one way because
of the position of the disc and disc brakes.
Holding the wheel upright, slide the forks over
the skewer with the springs on the outside. Make
sure the brake disc fits evenly in-between the
brake calliper.
With the lever still in the open position, hold onto
the quick release nut and start rotating clockwise
until the lever is firm to close. This might take a
few attempts to get the right level of resistance.
You want to be able to feel enough resistance
against the lever to know the wheel is safely
secured in the forks, but not too much that you
can’t close it.
It is important that you don’t just tighten the
nut with a closed lever, as this can become loose
while riding. It is also important you close the
lever tight enough so the wheel is firmly in place
and will not fall out if you meet an uneven road
surface. Check the quick release is secure before
every ride.
Brake Calliper
Brake Disc
Quick
release nut
Quick
release lever
Quick
release
skewer
