mychefcooking.com
PRODUCT MANUAL BAKE - DT.MP.BA.2103.2
30
This function will only continue with one cooking in the event of a power
failure and subsequent recovery of the power supply.
This function can be disabled by your dealer. Make sure that you fully
understand the risks of its use.
When a power failure and subsequent restoration of the power supply occur, the oven
recovers the cooking in progress (if any) and continues it with the same parameters as
before the power failure.
In the event of a power failure during a wash, the oven starts the self-cleaning process from
scratch.
6.3.
Errors and alarms
Errors and alarms can occur during the preparation and execution of cooking or washing
processes. If this is the case, the central display will show the error or alarm code.
Figure 22. Error indicator
The table below shows the various errors and alarms, as well as possible solutions to them:
Error
Internal definition
Clarification
0
NO ERROR
No error.
1
ERROR GENERAL PURPOSE
INPUT
Reserved. Not used.
2
ERROR OVERTEMPERATURE
Reserved. Not used.
3
ERROR OVERTEMPERATURE PCB
Overtemperature PCB. Check that the electronics'
cooling fans are working properly, that there is
enough space between the rear part and the wall,
and that the ambient temperature is not excessive.
4
ERROR COMMUNICATION
Inter-board communication not responding. Check
the cable between the power board and the control
board.
5
ERROR EEPROM
Processor communication and EEPROM not
working. Check the control board.
6
ERROR MOTOR
Engine
error. Check the motor wiring.
Overtemperature in the engine. Engine nailed
down.
7
ALARM WATER
Reserved. Not used.
