My Fireplace Blower FBL3642 Fan Kit, Installation Instruction, Page: 1 / 2

Exhaust Air
to
Outside
Room Air
in Bottom
Heated Air
out Top
FANS
Installation Videos:
MY
Fireplace Blower
MyFireplaceBlower.com
:
Installation Instructions:
Installer is responsible to check local codes
and read all instructions prior to installation.
Layout designed in U.S.A. © 2015
My Fireplace Blower
Burlington, Wisconsin
1-800-466-4045
Drywall dust or other fragments may be present in your fireplace’s vent space, clean this area before you install the
blower kit. Any bearing or motor damage resulting from this condition is not covered by the warranty policy.
Fan Kit LFBL3642 for LF and D Series Fireplaces
This Blower Kit is tested and safe when installed in accordance with these installation instructions. It is your re-
sponsibility to read all instructions and consult the Owner’s Installation Manual for your particular model number
for Supplemental Information before starting installation. Blower operates on 120V/60Hz power.
CLICK
High Quality Aftermarket Fireplace Blowers & Fans
1-800-466-4045
Check the contents of the carton.
Make sure nothing was damaged in shipment.
Do NOT install a damaged blower kit!
Blower Kit Parts
Step 1: Turn Off Fireplace and allow it to cool
down. Disconnect from 120V Power. Shut off
the Gas supply. (If applicable)
Step 2: Remove the lower vent louver/grill.
This provides access to the lower vent space
below the firebox. (Figure: 1)
CLICK
CLICK
NOTE: Diagrams and Illustrations NOT to Scale
Page 1 of 2
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK!
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE INSTALLING BLOWER!
When installed, make sure to contain any excess wire of the cord set;
Preventing it from making contact with moving or hot objects.
Description
Qty.
Fan - 3 Motor System
Power Cord Harness
ON/OFF Rocker Switch
Hardware
Installation Instructions
(Downloadable)
1
1
1
1
1
3-Prong to 2-Prong Adapter 1
Figure: 1
Step 3: Place the fan assembly with the blades point-
ing towards the rear of the fireplace. (Figure: 1 & 2)
Using 2 screws provided, fasten the bottom lip of fan
to the floor pan (There should be 2 existing holes). The
fan assembly may be pushed toward the back of the
vent space, use then the magnets to hold fan assembly
in place.(Figures: 1 & 2)
NOTE: Keep wire assembly away from the fan blades.