19
M1.1.PH400-PH400R.NLFREN
EN
TOOLS
4 Area of application
• This cable winch is used to hoist and lower loads.
• The transportation of persons or animals is not permitted.
• Loads can only be hoisted and lowered vertically.
• Other applications are excluded.
• While lifting a load if the raising power is so low that the load can’t be raised, check if the voltage on-site is 230 V. The
machine works efficiently with a voltage of 230 V, if the voltage does not meet the requirements, one must reduce the load.
5 Preparation
Prior to start-up operation, please be sure to make some preparations:
• Make sure the voltage of your power network complies with the voltage listed on the data plate and that the device is
equipped with the correct power plug.
•
Please make no-loading test before start-up operation at first, and please check:
a. The flexibility of up/down operating switch to insure the controlling of the hoisting and lowering of load hook.
b. The flexibility of up limit bracket to make sure the cut-off of circuit.
c. The flexibility of down limit bracket to make sure the cut-off circuit when the steel cable is nearly used up.
d. Any abnormal sounds when start-up operation.
e. The steel rope is possible damaged (split or bent), or reach 20 hours after using, change the rope immediately.
• Please inspect the brake disc before operating at every 20 hours after load. If the load is downslide or the brake is not
flexible, replace the relevant components in time.
• Please inspect the hook before operation is possible damaged or distortional, replace it in time.
• Operation using a residual current protective device (Red Emergency Stop Switch) offers additional protection under danger
and in emergency circumstances, then screw the switch head as the arrow direction to recover operation after remove the
danger.
• Please be sure to the enough lubricant on parts. Daub the lubricant on the load hook, cable drum shaft, slow down box,
and bearing every half a year.
Please daub the lubricant on the nesting of cable drum shaft when replace the steel cable every time. Immediately replace
the cable if damaged.
• Please perform any rework and maintenance tasks only if the power plug is disconnected.
• Please inspect the device for transportation damages. Immediately report any possible damages to your seller.
5.1 Correct winding of steel rope
6 Installation
The new electric hoist is easy to install with hanging hook rack. It can directly install on the crossbeam which external diameter
is suggested Φ 50 mm. The crossbeam is fixed in the stand pillar, which is mounted in the work site as user’s requirements. Pay
attention to mount the stand pillar firmly enough to loading weight long period.
Please make sure of the protection hook on proper position, and put the safety key onto the safety switch properly.
13
Clean the device using
a
damp
cloth
and
some
liquid
soap.
Never use
cleaning agents or
solvents,
these
could
damage the device's plastic parts.
Regularly inspect the total length
of
the
steel cable
for damages
as well as
the functionality
of
the limit
bracket (2)
(Wind
cable winch
until the limit
weight
(5)
activates
the limit bracket
of
the
limit
switch).
If the
steel cable
is damaged (split or bent
,
see
below)
,
a
professional must replace it using
original
replacement parts.
During
assembly of
the cable
,
it is imperative to remember the limit
weight (5)
in order to
ensure
a secure
limit
stop.
Inspect the free movement
of
all mechanical
components
after the power plug has been
disconnected.
Replace lost parts
only with original
parts.
Return the device to
your seller
to
ensure professional
recycling.
The machine should be repaired totally after continuously 20hours working time according to
operation frequency, usually make a repair annually. And the machine should be abandoned
reaching to 100hours working time.
Correct winding of steel rope
Problem-Solving
Common Malfunction
Cause
Solution
copyrighted
document
- all
rights
reserved
by
FBC
