MuxLab ProDigital 500790, Operation Manual

Page: 15 / 49

HDMI/IP PTZ Camera 30X Zoom, PoE Operation Manual
15
The correspondence between the camera and the Mini DIN pin:
4.7 Serial Communication Control
The camera can connect to a VISCA controller with an RS232C or and RS485 interface.
•
RS232 Communication Settings:
The camera may be controlled via RS232 when set to the following parameters:
Baud rate: 2400, 4800, 9600 or 38400 bit/s.
Start bit: 1 bit.
Data bits: 8 bits.
Stop bit: 1bit.
Parity bit: none.
• RS485 Communication Settings:
The camera may be controlled via RS485 when set to the following parameters:
Baud rate: 2400, 4800, 9600 or 38400 bit/s.
Start bit: 1 bit.
Data bits: 8 bits.
Stop bit: 1bit.
Parity bit: none.
When the camera is turned on, the Pan-Tilt function will move to the maximum top-right position
and then will return to the center (Home) position to complete an initialization process. (Note: If
the position preset 0 has been stored, the position preset 0 will be called up after the initialization
step). After the initialization process users can control the camera via the control commands in the