Muton XPJ-1682WR, Operation Manual

Page: 82 / 158

82 Setup 29: Start Feed
Setup 29: Start Feed
You can change the margin setting between images.
• Value greater than 0: The margin setting between images will be wider than when
setting “0”.
• Value equal to 0: The default margin setting between images will be applied.
• Value less than 0: The margin setting between images will be smaller than when setting
“0”.
Setting values
-10 mm to <0 mm> to 500.0 mm
<> indicates the initial value.
Note
With take-up system: if you want to set “Start Feed” to below 0, set “Page Gap” to “Narrow”.
If not, the Start Feed setting is not reflected properly.
"When the “Output Mode” is set to “Take Up”" P. 71
Setup 30: Alert Buzzer
Selects how to turn off the printer beep sound when an error occurs.
For unattended printing, you can select “Off” setting to avoid continuous buzzer
beep.
Setting values
Press any key on the front panel to turn off
beep sound.
This is the initially set value.
After several beeps, the printer
automatically turns off beep sound.
Setup 29
Start Feed
Start Feed:
(-10 - 500) 0 mm
Setup 30
Alert Buzzer
Alert Buzzer:
On
Alert Buzzer:
Off