Muton XPJ-1641SR, Operation Manual

Page: 117 / 166

Head cleaning 117
3 Cleaning
To maintain your printer in the best condition, cleaning must be performed as instructed.
If you find missing or thin lines on your print or nozzle check print, perform head cleaning.
Following cleaning modes are available:
Important!
When you perform “Little Charge” or “Initial Charge”,
• Do not power off the printer.
• Do not disconnect the power cords.
• Do not open the front cover and maintenance cover during cleaning.
• Do not release the pressure rollers.
• Do not remove ink bag cases and S/C cards from the printer.
• Be sure that remaining ink in the ink bag is enough to perform cleaning.
If cleaning is interrupted, it may consume more amount of ink.
Head cleaning
Short cleaning Consumes less ink than Normal cleaning.
Normal cleaning If nozzle missing is found on the nozzle check print, perform Normal cleaning.
Long cleaning If nozzle missing still persists after Normal cleaning, perform Long cleaning.
It consumes more ink than Normal cleaning.
Little Charge Little Charge gives higher cleaning than Long cleaning, but consumes large amount of ink.
To access to this menu, go to “Menu 3 Cleaning” > “Select Print Head” > “Cleaning Type”.
"Menu 3: Cleaning" P. 99
Initial Charge Initial Charge offers more powerful cleaning than Little Charge, but consumes large amount
of ink.
To access to this menu, go to “Menu 3 Cleaning” > “Select Print Head” > “Cleaning Type”.
"Menu 3: Cleaning" P. 99
Cleaning