After loading the media... 47
After loading the media...
[1]
Set the media holder at both edges of the media.
Important!
With the default settings, the printing operation starts 5 mm from the edge of the media. To hold down the media, make sure that the part overlapping the
media is less than 5 mm in length.
[2]
Lower the media setting lever.
[3]
Switch the front tension unit AUTO switch depending on how you set the
media.
• OUTSIDE ROLL: When setting the outside roll media
• INSIDE ROLL: When setting the inside roll media
[4]
Switch the front roll unit OPERATION switch depending on how you set the
media.
• SLACK: When using the slack take-up method
• TENSION: When using the tension take-up method
w
v
u
w
v
u
w
v
u
OUTSIDE ROLL
INSIDE ROLL
w
v
u
TENSION
SLACK
