40 Put the media through the Rear roller Assembly
[7]
Loosen the screws with a handle on left and right sides, and then adjust the
position of the roll media.
• Make sure that the center of the roll media and the center of the media feed
slot are aligned.
• Once adjustment is complete, tighten and secure the screw with a handle.
Put the media through the Rear roller Assembly
[1]
Move the MANUAL switch on the rear tension unit to the NORMAL side and
pull the roll media out about 1.5 m.
[2]
Put the roll media over the rear roller (A).
• For the outside roll media, see the left illustration.
• For the inside roll media, see the left illustration.
[3]
Put the roll media from the bottom to the top over the rear tension unit's
tension roller.
w
vu
NORMAL
A
A
A
A
