MUTOH ValueJet VJ-1324, Maintenance Manual, Page: 244 / 439

3.13.1 Removing Tension Arm P.3-162
3.13 Replacing Take-Up Unit (Option) VJ1324E-M-02
3.13 Replacing Take-Up Unit (Option)
This section describes the procedure to replace take-up unit.
CAUTION
• When replacing take-up unit, unplug the AC inlet cable and leave it for a while
before operation.
If operating while the AC inlet is still plugged in, it may damage the board or may
give an electrical shock to the operator.
• When handling board, do not touch the elements on the board with bare hand.
The elements may be damaged by static electricity.
3.13.1 Removing Tension Arm
1. Remove take-up scroller.
2. Remove the two screws (2 pieces) retaining tension arm R.
3. Remove tension arm L from tension fulcrum shaft.
4. Remove tension arm.
No. Name
1 Tension arm R
2 Tension arm R screw (hexagon socket pan flat head M4
×
10)
1
2
No. Name
1 Tension arm L
2 Tension fulcrum shaft
1
2