MUTOH ValueCut VC2-1300, Maintenance Manual

Page: 56 / 68

MAINTENANCE MANUAL
VC2E-MM-00
56
Media shifts away when plotting a long drawing.
[Check item] [Action]

Is the media aligned accurately? Reload the media.

Is the media pre-run with Jog key? Reload the media and pre-run.

Is the media edge cut straightly? Change the media.

Is the media too thin? Change the media.

Is there any paper chips or dust on the drum? Clean the surface of drum.

Is the drum or pinch roller worn? Replace the drum set or pinch roller.
The cutting line is wavy.
[Check item] [Action]

Is the screw on holder loose? Tighten the screw firmly.

Is the blade worn? Replace the blade.

Is the acceleration set too high? Set the acceleration to a lower value.

Is the carriage belt tension correct? Adjust the belt tension.

Is X or Y motor belt tension correct? Adjust the belt tension.

Is the carriage bearing or roller damaged? Replace the carriage.

Is the media length too short in X direction? Change the media.

Is the media too thin? Change the media.

Is the drum or pinch roller worn? Replace the drum set or pinch roller.

Is X or Y motors damaged? Replace the motor.
Data are missing when plotting.
[Check item] [Action]

The memory chip may have a problem. Replace the main board.
Serious error occurs when feeding media.
[Check item] [Action]

Are some media pulled out from the roll?
Enable “Auto media feed” on the panel.

Is X motor belt too tight? Adjust the belt tension.