Shaman CDL-01 Classic Delay
Article no.: 00034452
Precautions
1) Read these instructions before operating the unit.
2) Please heed all safety warnings and keep these instructions for future
reference. Follow all instructions.
4) Do not use this device near water or moisture.
5) Clean only with dry cloth.
6) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus that produce heat.
7) Only use attachments/accessories specified by the manufacturer.
8) Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as liquid has
been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been
dropped.
9) Battery not included. Use high quality 9V block battery or 9V/DC adaptor
(accessory) for ultimate performance.
Specifications
Shaman CDL-01: Classic Delay
Input Impedance: 1 M
Ω
Delay Time:
140ms … 360ms
Output Impedance: 1 K
Ω
Output Noise Level: <10mV
Controls:
Pedal Switch, Mix Knob, Time Knob, Rate Knob.
LED Indicator:
On/Off (serves also as battery check indicator)
Connectors:
6.35mm Input jack, 6.35mm output jack,
AC Adaptor Jack 9V/DC
Power Supply:
9 V DC: dry battery 9V type 6F22/9V, AC Adaptor
Current Draw:
20mA @ 9V/DC
Dimensions:
80 (W) x 120 (L) x 35/55 (H) mm
Weight:
280 g (battery not included)
1. DV 9V Input
The CDL-01 can be powered by 9V battery or 9V AC/DC adapter. The adapter must
have a barrel connector with center negative. The battery may be left in or taken out
when using an adapter. To install or replace the 9V battery, loosen the screws on the
bottom and remove the bottom plate. Always remember to unplug your guitar cords
from the pedal to conserve battery life. Some battery drain may take place when unit
is plugged in, even if the unit is bypassed.
2. STATUS LED
When the LED is on, the CDL-01 effect is active. When the LED is off, the CDL-01
is in bypass mode. The footswitch engages/disengages the effect.
3. INPUT Jack
This jack accepts input signals (coming from a
guitar, some other electric or electronic
musical instrument, or another effects unit).
The INPUT jack also serves as the power
switch. Power is turned on whenever a plug is
inserted into the INPUT jack, and is turned off
when the plug is disconnected. When not
using the unit, you should disconnect any cord
connected to the INPUT jack.
4. OUTPUT Jack
Connect this jack to your amplifier or some
other electric or electronic musical instrument,
or another effects unit.
5. Pedal Switch
This switch turns the effects ON/OFF.
6. Mix Knob
This knob adjusts the level of the effect sound.
Rotating the knob clockwise to increase the
effect sound. When rotating the knob anti-
clockwise to least position, the effect is played
at the same volume as the direct sound.
7. Time Knob
This knob controls the delay time. Rotating the knob clockwise the delay time will
be increased.
8. Rate Knob
This knob controls the feedback level. Rotating the knob clockwise increases the
number of times the delay sound is repeated.
Musikhaus Kirstein GmbH
Bernbeurenerstr. 11 / 86956 Schongau / Germany
Phone: 0049-8861-909494-0 Fax: 0049-8861-909494-19
