Shaman CCH-01 Classic Chorus
Article no.: 00034451
Precautions
1) Read these instructions before operating the unit.
2) Please heed all safety warnings and keep these instructions for future
reference. Follow all instructions.
3) Do not use this device near water or moisture. Clean only with dry cloth.
4) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus that produce heat.
5) Only use attachments/accessories specified by the manufacturer.
6) Refer all servicing to qualified service personnel. Servicing is required
when the device has been damaged in any way, such as liquid has
been spilled or objects have fallen into the device, the effect pedal has
been exposed to rain or moisture, does not operate normally, or has been
dropped.
7) Battery not included. Use high quality 9V block battery or 9V/DC adaptor
(accessory) for ultimate performance.
Specifications
Shaman CCH-01: Chorus
Input Impedance: 470K
Ω
Max Output Level: 120mV
Output Impedance: 1 K
Ω
Controls:
Pedal Switch, Speed Knob, Depth Knob, Level Knob.
LED Indicator:
On/Off (serves also as battery check indicator)
Connectors:
6.35mm Input jack, 6.35mm output jack,
AC adaptor jack 9V/DC
Power Supply:
9 V DC: dry battery 9V type 6F22/9V, AC Adaptor
Current Draw:
9mA @ 9V/DC
Dimensions:
80 (W) x 120 (L) x 35/55 (H) mm
Weight:
280 g (battery not included)
1. DV 9V Input
The CCH-01 can be powered by 9V battery or 9V AC/DC adapter. The adapter must
have a barrel connector with center negative. The battery may be left in or taken out
when using an adapter. To install or replace the 9V battery, loosen the screws on the
bottom and remove the bottom plate. Always remember to unplug your guitar cords
from the pedal to conserve battery life. Some battery drain may take place when unit is
plugged in, even if the unit is bypassed.
2. STATUS LED
When the LED is on, the CCH-01 effect is active.
When the LED is off, the CCH-01 is in bypass
mode. The footswitch engages/disengages the
effect.
3. INPUT Jack
This jack accepts input signals (coming from a
guitar, some other electric or electronic musical
instrument, or another effects unit).
The INPUT jack also serves as the power switch.
Power is turned on whenever a plug is inserted into
the INPUT jack, and is turned off when the plug is
disconnected. When not using the unit, you should
disconnect any cord connected to the INPUT jack.
4. OUTPUT Jack
Connect this jack to your amplifier or some other
electric or electronic musical instrument, or another
effects unit.
5. Pedal Switch
This switch turns the effects ON/OFF.
6. Speed Knob
This knob controls the speed of the chorus effects. Rotating the knob clockwise
increase speed and deepen the effect. Rotating the knob counter-clockwise slow the
movement and decrease the depth.
7. DEPTH Knob
This knob controls the depth of the chorus effects. Rotating the knob clockwise
increase depth and counter-clockwise to decrease.
8. Level Knob
This knob adjusts the mixing level of the effect sounds. Rotating the knob clockwise
increase the amount of the effect sound and vice versa.
Musikhaus Kirstein GmbH
Bernbeurenerstr. 11 / 86956 Schongau / Germany
Phone: 0049-8861-909494-0 Fax: 0049-8861-909494-19