6
3.2
Not intended use
The possibility of labelling, as well as the durability and quality of the
inscription cannot be guaranteed in the following shown cases. There
is no guarantee, no warranty and no support.
Not provided is labelling of non-approved Murrplastik material.
Not provided is using of ink not approved by Murrplastik.
Not provided is labelling by means of software or operating systems
which are not approved by Murrplastik.
Not provided is labelling of paper.
3.3
Choosing an installation site
Operate the device in well ventilated environments only.
Position the device on a level, stable surface that is larger than the
device itself. The device will not operate properly if it is tipped up or
tilted.
Avoid using locations where the printer will be exposed to extreme
fluctuations of temperature or humidity. Constant room temperature
is recommended. Protect the device from direct sunlight, excessive
light and sources of heat.
Avoid using sites that might be exposed to impacts or vibrations. This
also applies to the transport of the device.
Keep the device away from dusty or humid areas.
Position the device near to a mains socket, so that no extension cable
is required if possible.
When transporting or storing the printer, it must not be tipped up,
stood on one of its sides or turned upside down.
If you ignore this, ink may leak and/or cause a short circuit.