© Munters AB, 2020
99
NOTE
For information on Brooding, refer to Brood Area, page 142.
8.2.2
D
EFINING
H
OUSE
M
ODES
“Flock Settings” Settings page defines basic parameters for houses when these room are NOT in Growth
mode. All other modes have the same parameters.
1. Click
.
2. Click the required tab and define:
o
Ventilation Output: Define the ventilation output by percentage. (Empty and Pre-Heating).
o
Heat Output: Define the heat output.
o
Ventilation Level: Define the ventilation level (Catching mode only)
0 – 10 Basic
11 – 20 Extra
T1 – T3 Tunnel
o
Lights/Lights Intensity: Enable lighting and set the intensity (Catching mode only)
o
Alarm: Enable or disable temperature alarms.
o
Temp Low/High Alarm: Set the temperature below/above which the controller activates
a temperature alarm.
o
Timer: Enable or disable. Define which timers operate in this mode. Refer to Defining the
Timer, page 72 and Timers, page 162 for details on mapping and defining the Timers.
Summary of Contents for TRIO
