mundoclima Aerotherm MAM Gran potencia-V10, Installation And Owner'S Manual

Page: 46 / 81

42
DIP switch is located on the hydraulic module main control board (see "9.3.1 main control board of hydraulic module") and
allows configuration of additional heating source thermistor installation, the second inner backup heater installation, etc.
10.2.1 Function setting
10.2 DIP switch settings overview
T4H1 T4H2
T1SETH2
T1SETH1
T4
T1S (T1S2)
3.The automatic setting curve for heating mode
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
State:In the setting the wired controller, if T4H2<T4H1, then exchange their value; if T1SETH1<T1SETH2, then exchange
their value.
T4 -10 ≤ T4 ＜ 15 15 ≤ T4 ＜ 22 22 ≤ T4 ＜ 30 30 ≤ T4
1-T1S 16 11 8 5
2-T1S 17 12 9 6
3-T1S 18 13 10 7
4-T1S 19 14 11 8
5-T1S 20 15 12 9
6-T1S 21 16 13 10
7-T1S 22 17 14 11
8-T1S 23 18 15 12
T4 -10 ≤ T4 ＜ 15 15 ≤ T4 ＜ 22 22 ≤ T4 ＜ 30 30 ≤ T4
1-T1S 20 18 17 16
2-T1S 21 19 18 17
3-T1S 22 20 19 17
4-T1S 23 21 19 18
5-T1S 24 21 20 18
6-T1S 24 22 20 19
7-T1S 25 22 21 19
8-T1S 25 23 21 20
4.The environment temperature curves of the low temperature setting for cooling mode
5.The environment temperature curves of the high temperature setting for cooling mode
T4C1 T4C2
T1SETC2
T1SETC1
T4
T1S (T1S2)
6.The automatic setting curve for cooling mode
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
State:In the setting the wired controller, if T4C2<T4C1,then exchange their value; if T1SETC1<T1SETC2, then exchange
their value.