Multiva FX300 SeedPilot, Operation And Maintenance Manual

Page: 184 / 208

Figure. 7.9.2.1. - 251. Detaching the bearing housing
2. Loosen the bearing bolt (2) and remove the bolt and the washer (1).
The left-side disc has a left-handed thread and the right-side disc has a right-
handed thread.
3. Remove the bearing housing (3).
Use a bearing puller to remove the bearing housing.
7.9.2.2. Installing the disc
Install the bearing in accordance with section 7.9.3.2. Installing the bearing.
Figure. 7.9.2.2. - 252. Installing the bearing housing
1. Clean the plane surface (3) of the bearing housing.
2. Mount the bearing to the coulter axle.
3. Insert the M16 washer (1) and fasten the M16 bolt (2).
Operation and maintenance manual
FX300 and FX400 SeedPilot
1.00
184 (208)