Multiva FX300 SeedPilot, Operation And Maintenance Manual

Page: 125 / 208

The calibration test quantity obtained corresponds to the area of 100 m², so the
quantities for a hectare will be hundredfold.
If the weighing result does not match the desired quantity, adjust the length of
the roller with the gearbox control lever. The feeding quantity increases when the
value of the adjustment scale increases.
8. Repeat the calibration test. Ensure the result is close enough to the target quantity.
9. Place the calibration trays in the machine. Ensure that the trays are in the correct order
and that they are connected to each other correctly.
10. Insert the cotter pins.
11. Turn the crank to bring the calibration trays to the seeding position.
12. Put the transmission cover back in place.
6.8.7. Calibration test of small seed hopper
DANGER
If the machine is equipped with a SeedPilot or SeedPilot ISOBUS control system, switch
on the STOP ALL function in accordance with section 6.3.1. Using the STOP ALL
function.
DANGER
Shut off the tractor, remove the key from the ignition and engage the parking brake
before running a calibration test. If the machine is equipped with middle markers, close
the middle marker shut-off valves in accordance with the instructions in section 3.4.
Using the middle marker ball valves.
Figure. 6.8.7. - 158. Feeder funnel assembly of the small seed hopper
1. Open the four locking pins (2) of the feeder funnel assembly.
2. Set the feeder funnel assembly in the calibration test position by folding the funnel down
and pushing it towards the hopper. Lock the feeder funnel assembly in place by using the
locking pins and the lower hole (1).
3. Insert the 2 calibration trays (3, 4) into place on the rail under the small seed hopper.
Operation and maintenance manual
1.00 FX300 and FX400 SeedPilot
125 (208)