Multiva FX300 Comfort, Operation And Maintenance Manual

Page: 61 / 189

Fasten the cable properly so that it is not pinched during turns or lifting.
Figure. 5.2.2. - 60. Fastening the Comfort control panel
2. Fasten the display bracket (3) to the plate (5) by using a screw (6).
3. Fasten the display bracket (4) to the cabin with two fastening screws (4).
Attach the display in a location where view is not obstructed but where the
display is easily viewable by turning one's glance while driving. Fasten the display
at a suitable height so that the buttons can be reached effortlessly.
4. Fasten the controller display (1) to the display bracket (3) by using a screw (2).
5.3. Connecting to tractor
DANGER
Crushing hazard when connecting and disconnecting the seed drill. The minimum safe
distance - 5 m. Exercise extreme caution when there are personnel near the seed drill
and tractor giving instructions on connecting and disconnecting.
Wear protective gloves when connecting the seed drill to the tractor.
1. If the machine is equipped with a wheel packer, adjust the length of the wheel packer
drawbar in accordance with section 5.3.1. Adjusting the length of the boom of the wheel
packer.
2. Connect the drawbar of the seed drill to the tractor hitch or the wheel packer draw boom
to the tractor’s link arms.
3. Raise the machine with the tractor hydraulics.
4. Raise the ground support to the top position according to the instructions given in
section 5.3.2. Using the ground support.
Operation and maintenance manual
1.00 FX300 and FX400 Comfort
61 (189)