Multiva FX300 Comfort, Operation And Maintenance Manual

Page: 146 / 189

CAUTION
Do not allow water to enter electrical instruments.
3. Lubricate all lubrication points in accordance with section 7.2. Lubrication.
Damaged paint can be touched up after washing. The painted surface can be protected
with a light application of oil, using protective oil intended for the purpose. Entry of
protective oil on rubber and plastic parts should be avoided.
7.3.4. Cleaning the coulter discs
Wear protective goggles and protective gloves when cleaning the discs of the coulters.
Figure. 7.3.4. - 190. Discs of the coulters
1. Clean the discs (1) of the coulters with a power washer.
Clean the clearance between the scraper and covering wheel as well.
2. Apply protective oil on wear parts to protect them from corrosion.
3. Once the discs are dry, turn each pair of coulter discs a few turns so that the scrapers
remove the dry dirt from the inside of the discs.
7.3.5. Cleaning the feeder units
Wear protective goggles and protective gloves when cleaning the feeder .
Clean the feeder units at the end of the seeding season.
Operation and maintenance manual
FX300 and FX400 Comfort
1.00
146 (189)