2944
An area of 100 m² is obtained by turning the crank 22 rounds.
8. Pull out the calibration test trays of the small seed hopper and weigh the quantities they
now contain.
The calibration test quantity obtained corresponds to the area of 100 m², so the
quantities for a hectare will be hundredfold.
If the weighing result does not match the desired quantity, adjust the length of
the roller in accordance with section 6.5.10. ADJUSTING THE WIDTH OF THE
9. Repeat the calibration test. Make sure that the result is sufficiently close to the target
quantity.
10. Reattach the feeder funnel and cotters.
11. Reinsert the calibration test trays.
12. Put the transmission cover back in place.
6.8. Adjusting the seeding depth of the coulter
Figure. 6.8. - 95. Seeding depths
The seeding depth of the coulter is adjusted per each coulter by means of the covering
wheel. The label (1) shows the seeding depths in millimetres.
Operation and maintenance
manual
Cerex 300
1.00
87 (156)
Summary of Contents for Cerex 300 SeedPilot
Page 159: ...Hydraulic schematic Appen dix 2 Cerex 300 1 Appendix 2 Hydraulic schematic...
Page 160: ...Hydraulic schematic Appen dix 2 Cerex 300 2...
Page 161: ...Electrical Diagram Annex 3 Cerex 300 1 Annex 3 Electrical Diagram...
Page 162: ...Electrical Diagram Annex 3 Cerex 300 2...
