2887
2888
2889
4.1.3.3. Resetting the area counter
1. Press the C key repeatedly until the area symbol HA.1 and the value are displayed on the
screen.
2. Press and hold the SET key for approximately 2 seconds until the area value starts to
ash.
3. Press the C key repeatedly until the value is reset.
4.1.3.4. Switching power on and off
The device is powered by two 1.5 V AA batteries.
The device starts operating when it receives a signal from the sensor.
1. Switch the device on manually by pressing the SET or C key.
The display shows the number of the program version.
The device checks the condition of the batteries. If the display shows text "-bL"
and the device switches off, change the batteries. If text "-bL" ashes during use,
the battery voltage starts to decrease and the batteries should be changed.
The device switches off automatically if it has not received a pulse from the
sensor for 0.5 - 1.5 hours or if no key has been pressed. All values are stored in the
memory.
2. Switch the device off manually by pressing and holding the C key for approximately 4
seconds.
The display shows text "stop" for approximately one second, after which the
device switches off.
4.2. RDS G-Wizard
The RDS G-Wizard controller is an accessory. This chapter describes the controller and provides
instructions on using it.
Operation and maintenance
manual
Cerex 300
1.00
25 (156)
Summary of Contents for Cerex 300 SeedPilot
Page 159: ...Hydraulic schematic Appen dix 2 Cerex 300 1 Appendix 2 Hydraulic schematic...
Page 160: ...Hydraulic schematic Appen dix 2 Cerex 300 2...
Page 161: ...Electrical Diagram Annex 3 Cerex 300 1 Annex 3 Electrical Diagram...
Page 162: ...Electrical Diagram Annex 3 Cerex 300 2...
