Multiva Cerex 300 Comfort, Operation And Maintenance Manual

Page: 71 / 187

6.3.3. Using the tramline counter
Tramline counter correction
Figure. 6.3.3. - 80. Tramline counter correction
The ADD TRAMLINE COUNTER button (2) can be pressed to add a tramline (1) on drive-
around runs or subtract a tramline (1) on back-and-forth runs, if the machine is
unintentionally raised one too many times.
1. Add a tramline by pressing the ADD TRAMLINE COUNTER button.
2. Subtract a tramline by pressing the ADD TRAMLINE COUNTER button several times in a
row until the correct number of tramlines is set.
The number of tramlines will increase at rst and then start from 1 again.
Stopping the tramline counter
Figure. 6.3.3. - 81. Stopping the tramline counter
The tramline counter can be stopped when work is interrupted and when lling the
machine. The tramline counter can be stopped when the lift inhibit function is in its
normal mode (1/3). See section 6.3.1. Active operating mode.
1. Stop the tramline counter by pressing the STOP TRAMLINE COUNTER button (1).
Operation and maintenance manual
1.00 Cerex 300 and Cerex 400 Comfort
71 (187)