INSTALLING THE DEVICE
MultiConnect
®
microCell MTCM2-L6G1 User Guide
15
Chapter 4 – Installing the Device
Installing a SIM Card
This model requires a CBRS SIM card, which is supplied by your service provider. To install the SIM card:
1.
Locate the SIM card slot on the side of the modem. The slot is labeled SIM.
2.
Slide the SIM card into the SIM card slot with the contact side facing up as shown. When the SIM card is
installed, it locks into place.
Removing a SIM Card
To remove the SIM card, push the SIM card in. The device ejects the SIM card.
Installing the Device
Important:
Install drivers on your computer before connecting the device.
1.
Connect antennas to the antenna connectors.
2.
Connect the USB connector to your computer or other USB high power device, such as a hub.
3.
The POWER LED lights after the device powers up.
Connecting to a CBRS Network
After the POWER LED lights up:
By default auto connect is enabled so if no APN is required it will connect automatically.
If APN is Required:
1.
Log into a terminal program, such as as PuTTy.
2.
Go to AT command port and enable echo with ATE1 by default it is disabled.
3.
Set APN using AT+CGDCONT=1,"IP","APN#", where APN# is the APN for your device.
Basic AT Commands
Use terminal program, such as PuTTY, and AT command to query modem information and status
Check SIM status