MultiModemDSVD User Guide
34
Command:
&T
n
V.54 Test Commands
Values:
n
= 0, 1, 3, 4, 5, 6, 7, or 8
Default:
None
Description:
The modem can perform selected test and diagnostic func-
tions. A test can be run only when the modem is in asynchro-
nous operation in non-error-correction mode (normal or direct
mode). For tests 3, 6, and 7, a connection between the two mo-
dems must first be established. To terminate a test in progress,
the escape sequence (
+++
) must be entered first, except for pa-
rameters 7 and 8. If
S18
is non-zero, a test terminates automati-
cally after the time specified by
S18
and displays the
OK
mes-
sage.
&T0
Abort. Stop any test in progress.
&T1
Start local analog loopback, V.54 Loop 3. If a connection exists
when this command is issued, the modem hangs up. The
CON-
NECT XXXX
message is displayed upon the start of the test.
&T3
Start local digital loopback, V.54 Loop 2. If no connection ex-
ists,
ERROR
is returned.
&T4
Enables acknowledgment for remote digital loopback request.
&T5
Ignores acknowledgment for remote digital loopback request.
&T6
Requests a remote digital loopback, V.54 Loop 2, without self-
test. If no connection exists,
ERROR
is returned. The
CON-
NECT XXXX
message is displayed upon the start of the test.
&T7
Requests a remote digital loopback, V.54 Loop 2, with self test.
(In self test, a test pattern is looped back and checked by the
modem..) If no connection exists,
ERROR
is returned. When
the test is terminated, the number of detected errors is re-
ported to the computer.
&T8
Starts local analog loopback, V.54 Loop 3, with self test. If a
connection exists, the modem hangs up before the test begins.
When the test is terminated, the number of detected errors is
reported to the computer.
Command:
&V0
Display Current Configuration
Values:
0
Default:
None
Description:
Displays the current (active) configuration, the two stored user
profiles, and the first four stored telephone numbers. The
stored profiles and telephone numbers are not displayed if the
NVRAM is not operational as detected by the NVRAM test
during reset processing.
Command:
&V1
Display Last Connection Statistics
Values:
1
Default:
None
Description:
Displays statistics for the last connection.
Summary of Contents for MT5600DSVD2
