Conduit IP67 Base Station 200 Series
CAUTION:
Read installation instructions and safety information before starting Base Station installation. Do not connect power until
directed to do so. If you do not install the accessories when you install the Base Station, cover the LoRa connectors to keep them dry.
IMPORTANT:
Do not attempt to disassemble the Base Station. There are no serviceable parts. Opening the enclosure without
authorization may void the warranty.
Package Contents
Note:
Package contents vary by model.
Item
Description
Quantity
1
MTCDTIP2 Base Station
1
2
LoRa antennas
1
3
Installation Guide
1
Warning and
Caution
Warning and Caution symbols mean potential danger. You are in a situation that could cause bodily injury. Before working on any equipment, be aware of
hazards in the installation area and be knowledgeable about electrical circuitry. Be familiar with standard practices for preventing accidents.
Pour une traduction en français, reportez-vous à PoE Safety dans le Guide du matériel. For other translations of key cautions and warnings, refer to the
Conduit IP67 Series 200 Base Station MTCDTIP2 Hardware Guide
for your model available at
www.multitech.com/brands/conduit-ip67-200
WARNING:
Only trained and qualified personnel should install, replace, or service this equipment. Installation must comply with local and national
electrical codes.
When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Disconnect PoE power (Ethernet PoE port) before servicing the Base Station.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
This device is not designed or approved to be used in any Hazardous Locations. Do not install or operate device if area is known to be an explosive
environment.
Externally ground this equipment using a customer-supplied ground wire before applying power. Contact an electrician if you are uncertain that suitable
grounding is available. Refer to
Installing the Ground Wire
instructions.
All wall mounting installations are subject to the acceptance of local jurisdiction.
Do not locate antenna near overhead power lines or other electric light or power
circuits, or where it can come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, because they may
cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes.
CAUTION:
Power over Ethernet (PoE) Certification does not apply or extend to voltages outside of standard PoE range. PoE range for the MTCDTIP2 is 42.5-
57 VDC. Any PoE voltages outside this range have not been evaluated by UL or MULTITECH. The end user supplies the PoE cable. This cable must
be suitable for an outdoor location. This is an 802.3at Type 2 device. For more information, refer to the Conduit IP67
Base Station PoE Application Note (S000678).
Ethernet port is not designed to be connected to a public
telecommunication (PSTN) or any other connection other than
IEEE 802.3-2012 Power over Ethernet devices.
Do not remove product labels.
Conduit IP67 Base Station 200 Series
Models: MTCDTIP2-EN-B11EKP-LEM, MTCDTIP2-EN-B11EKP-LEL,
MTCDTIP2-L4E1-B11EKP-LEM, MTCDTIP2-L4E1-B11EKP-LEL
Part Number: 82130900L
Copyright © 2021 by Multi-Tech Systems, Inc.
Additional Documentation
For additional documentation, find your model on this page:
www.multitech.net/developer/basestation
. If this document has been up-
dated, the update will be available at that location.
Conduit IP67 Base Station Hardware
Guide:
Model specific, includes hardware, regulatory, and safety information.
AT Command Reference Guide: For LTE models only
, model specific. Lists the commands and parameters used to com-
municate with your device.
mPower Software Guide: For mPower models only
. Includes steps for configuring and using devices using the mPower
platform
.
mLinux Developer Resource:
For mLinux models only
, includes information for the mLinux platform, advanced mPower infor-
mation, and LoRa. Go to
multitech.net/developer/software/mlinux/
POE Application Note
: Includes standards, recommendations, and troubleshooting.
Multi-Tech Systems, Inc.
2205 Woodale Drive
Mounds View, Minnesota 55112
Phone:
763-785-3500 or 800-328-9717
Support
Portal:
support.multitech.com
Knowledge Base:
multitech.com/kb.go
Europe, Middle East, Africa:
+(44) 118 959 7774
U.S., Canada, all others:
(800) 972-2439 or (763) 717-5863
Safety Instructions
For safety and to achieve a good installation, please follow these safety precautions:
Consider safety and performance when selecting an installation site. Remember electric power lines and phone lines look alike.
Assume that any overhead line can cause bodily harm or death.
Call your power company and ask them to look at your proposed installation. This is important if raising a mast or tower.
When installing the device:
Do not use a metal ladder.
Do not work on a wet or windy day.
Dress properly—shoes with rubber soles and heels, rubber gloves, long-sleeved shirt or jacket.
If any part of the antenna system comes in contact with a power line, do not touch it or try to remove it yourself. Call your local
power company. They will remove it safely. If an accident occurs, call for emergency help immediately.
IMPORTANT:
Refer to
Warnings and Cautions
on the back page for additional information.
Conduit
®
IP67 Base Station 200 Series
MTCDTIP2 Hardware Installation Guide
Requirements
In addition to the Base Station and included accessories, you will need:
1 - PoE Injector. For requirements, refer to
Conduit IP67 Base Station PoE Application Note
(S000678).
1 - Cat 5 or greater Ethernet cable rated for outdoor use.
1 - Micro SIM (3FF) card (
LTE models only
). MultiTech recommends using a SIM card rated for the climate where the device will be installed.
1 - 14 AWG or larger ground wire with a closed loop terminal. For details, go to
Installing a Ground Wire
in this document.
1 - Phillips screwdriver.
Related Accessories
PoE injectors, mounting kits, lightning arrestors, and accessories are available through
https://www.multitech.com/brands/conduit-ip67-200
Note:
The LoRa antenna can be directly mounted on the Base Station or up to 5 feet away if necessary for your location.
