Multitech CC1600 Series, Owner'S Manual

Page: 45 / 76

45
Chapter 4 - Modem Commands, S-Registers & Result Codes
Password Commands
COMMAND: #Ixxxxxxxxxx
VALUES: n/a
DEFAULT: #IMULTITECH
DESCRIPTION: Login Password is any keyboard characters (x) (upper/lower case
sensitive), minimum 6 and maximum 10 characters. The default
Login Password is MULTI-TECH.
COMMAND: #Syyyyyyyyyy
VALUES: n/a
DEFAULT: #SMODEMSETUP
DESCRIPTION: Set-up Password is any keyboard characters (y) (upper/lower case
sensitive), minimum 6 and maximum 10 characters. The default
Set-up Password is MODEMSETUP.
4.2 S-Registers
Certain Command Mode configurations are stored in memory registers called, S-Registers. The S
command is used to assign a value to, and to read the current value of an S-Register. To assign a
value to an S-Register, enter the letter S, followed by the S-Register number and an equals sign (=),
and then a decimal response to the message “ENTER THE NEW VALUE IN DECIMAL FORMAT”.
To read an S-Register value, enter the letter S followed by the S-Register number and a question
mark (?), then hit RETURN. To verify that the S-Register value was entered correctly, enter for
example, ATS8? and hit RETURN. You should receive a response of the assigned value given to
that S-Register.
S0
Number of Rings Until Modem Answers
Unit: 1 ring
Range: 0-255
Default: 1
Description: Sets the number of rings before the modem answers.
S1
Rings Which Have Occurred
Unit: 1 ring
Range: 0-255
Default: 0
Description: Counts the number of rings that have occurred.
S2
Escape Code Character
Unit: ASCII Character
Range: 0-127
Default: 43 (+ sign)
Description: Defines the escape code character.
S3
Return Character
Unit: ASCII Character
Range: 0-127
Default: 13
Description: Defines the character recognized as Carriage Return (RETURN) or “Enter”.