MultiScree
133
Load Sequences
The Load Sequences function enables you to load single or multiple sequences
stored in a sequence transfer file (that was saved previously using the Save Se-
quences function) from an external source, whether it be over a network or from
a storage device.
[a]
From the Sequence Editor click on the
Config
button.
[b]
Click on the
BackUp & Restore
button.
[c]
Click on the
Load Sequences
button. This will bring up the following
screen labelled
Load Sequences
:-
3.
Parent Folder
returns you to the parent folder if you have navi-
gated into a sub-folder.
4.
File Types
allows you to view all the files from the source folder
or drive, not just the sequence transfer files. By default this is off,
which is indicated by a red cross. To view all the files on the source
folder or drive click on the button with the red cross and it will
change to a green tick.
[d]
Select where to load the sequences from by clicking on the drop down ar-
row next to the box labelled above as
Source
(
1
). The source can be either
an external storage device or one of the Network Folders that has been set
up previously.
[e]
Once a source has been selected your screen should look similar to below.
3. Parent Folder
Up
2. Sequences
Available
1. Source
4. File
Types
Summary of Contents for In House TV Communication System
Page 1: ...OPERATOR S MANUAL www multiscreen biz info multiscreen biz...
Page 8: ...MultiScree 8...
Page 234: ...MultiScree 234...
