WALK-BEHIND TROWELS — HANDLE INSTALLATION INSTRUCTIONS P/N 20485 — REV. #4 (09/18/14) — PAGE 1
Walk-Behind Trowels
Handle/Throttle Assembly Installation
The following instructions are intended to assist the user in the installation of the Standard Handle (SXH/SXHD) and Quick
Pitch™ (QXH/QXHD) on the Multiquip walk-behind trowels. It is not intended to take the place of the Operation and Parts
Manual shipped with the trowel. Refer to the Operation and Parts Manual for SAFETY, OPERATION, and MAINTENANCE
Information. If you did not receive a manual with your trowel, contact Multiquip at (800) 421-1244 for a replacement.
REQUIRED TOOLS
Ratchet/Socket set
Wrench
Phillips Screwdriver
PARTS
Verify that all parts are accounted for. See Figure 1 and
Table 1.
Figure 1. Standard/Quick Pitch
TM
Trowel Handle
STANDARD
HANDLE
1
QUICK PITCH™
HANDLE
1
3
2
4
5
6
7
INSTRUCTIONS
OR
WORK SAFELY!
Only a
qualified service technician
with proper training
should perform this installation. Follow all shop safety rules
when performing this installation.
PREPARATION
1. Make sure trowel is turned off and engine is cool.
2. Place the trowel in an area free of dirt and debris. Make
sure it is on secure level ground.
Table 1. Handle Parts
Item
No.
Part No.
Description
Qty.
Remarks
1
SXH
or QXH
Standard Handle
or Quick-Pitch™ Handle
1
Includes
item 2
2
22100
Handle Installation Kit
1
Includes
items 3-7
3
1493
3/8-16 x 3 1/4 HHC Screw
1
4
10133
3/8-16 Nyloc Nut
2
5
10136
3/8 Flat Washer
2
6
20485
Installation Instructions
1
7
21746
Spring, Primary Throttle Return
1
