25
P54
K/K2B/K4B
Operation :
5.4 Starting the engine :
1. Move the gas lever to the "Start" position (Fig. 8, Page 20).
2. Move the control lever for the pusher blade to the neutral position (Page 19, Fig. 5).
3. Turn the ignition switch "Z" to the "I" position (Page 19, Fig. 4).
4. Turn the vibration switch "VS" to the central position (Page 19, Fig. 4)
5. The pedals must not be actuated during engine start-up. (Page 19, Fig. 7)
The oil gauge pilot lamp "ÖK" and charge pilot lamp "LK" light up
When starting the engine, the start instructions of the engine manufacturer must be observed.
•
Turn the ignition switch to the "II" position. The engine starts.
•
Immediately let go of the ignition key once the engine is running.
Note :
The starter must never be actuated while the engine is already running! This
could lead to serious damage to the starter and the starter ring gear
Remark :
Before starting work, allow the engine to warm up briefly in idle operation.
______________________________________________________________________________________
5.5 Starting with jump leads :
Note :
When starting with jump leads, always ensure that the plus pole is connected
first then the minus pole (earth cable).
When the engine has started, first disconnected the minus pole
and then the plus pole.
Failure to comply with this instruction can result in serious
damage to the electrical equipment of the machine.
•
The RW 3000 is equipped with two batteries,
which are located on either side of the oil tank.
•
For jump starting, it is sufficient to unscrew the lid of one
battery compartment. The machine can be started optionally
from either side. (Fig. 19)
Fig. 19
Summary of Contents for P54K-K2B-K4B
Page 2: ...Diesel engine exhaust and some of...
Page 12: ......
