PAGE 14 — MC94SK/PK CONCRETE MIXER • OPERATION MANUAL — REV. #0 (06/22/22)
BASIC COMPONENTS (MIXER)
Figure 3. Mixer Major Components
1.
Steel Mixing Drum
— This mixer uses a 6 cu. ft
steel
mixing drum. This drum is to be used for mixing of
concrete. Always clean the drum after each use.
DO
NOT
use this mixing drum for the mixing of volatile
liquids.
2.
Dump Latch
— To rotate the mixing drum, this latch
must be in the up position. To lock the drum, place the
latch in the down position.
3.
Dump Gear Guard
—
NEVER
operate the mixer
with this guard removed. Its purpose is to prevent dirt
and debris from entering the dump gear. In addition,
operator clothing could become entangled in the dump
gear, causing severe injury and bodily harm.
4.
Handwheel
— Turn this wheel clockwise or counter-
clockwise to rotate the mixing drum. Remember the
dump latch must be in the
up position
in order for the
mixing drum to be rotated.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
5.
Zerk Fittings
— There are
four
grease zerk fittings
that require lubrication, three are on the
yoke
, and
the remaining fitting is located in the center of the
handwheel
. Lubricate these fittings as referenced in
the maintenance section of this manual.
6.
Safety Chain
— This mixer uses a 3/16-inch thick,
72-inches long zinc-plated saftey chain.
ALWAYS
connect the safety chain when towing.
7.
Tow Bar
— This mixer uses various towing bars, please
reference the frame assembly drawing and parts list
in this manual to determine which tow bar meets your
requirements.
8.
Spring Suspension
— This mixer uses a
spring
type
suspension. Check the mounting hardware for bolt hole
elongation and tightness. See maintenance section of
this manual for recommended maintenance.
9.
Chock Blocks
— Place these blocks (not included as
part of the mixer package) under each mixer wheel
to prevent rolling, when mixer is not connected to the
towing vehicle.
10.
Tires Ply
— The tire ply (layers) number is rated in
letters. This mixer uses 13-inch 2-ply tires. Replace
with only recommended type tires.
11.
ON/OFF Switch (gasoline only)
— This switch is
provided on
mixer with
gasoline
engines only and is
located on the side of the mixer cabinet. When activated
it will shut down the engine. Pull out when starting the
engine.
12.
Cabinet/Latch
— Encloses engine and electric motor.
NEVER
run mixer with cabinet removed. Use latches
to secure engine compartment cabinet.
13.
Mixing Blades (Steel)
— Used for the mixing of
concrete. When blades show signs of wear, entire
steel mixing drum assembly must be replaced. See
steel mixing drum assembly in the parts section of
this manual.
14.
Forklift Pockets
— When lifting of the mixer is required,
use these fork lift pockets to lift the mixer. Remember to
insert the forks of the forklift a minimum of 24 inches
into the lift pockets.
Discount-Equipment.com
