![Multiplex N2-Fusion ND21RS00 Installation, Operation & Maintenance Manual Download Page 27](http://html1.mh-extra.com/html/multiplex/n2-fusion-nd21rs00/n2-fusion-nd21rs00_installation-operation-and-maintenance-manual_1854680027.webp)
Part Number: 9290312 October/22/2018 27
Rinsing
Wipe down each nozzle with wet clean towel and allow to
air dry. If Keg was disconnected and cleaned/sanitized, wipe
down connectors with clean wet towel and allow to air dry.
Clean n‑line Strainer
1. Locate the in-line coffee strainer on the celling of the
refrigeration cabinet.
Bowl
HOW TO REMOVE STRAINER
A. First depressurize the system and disconnect the
keg.
B. Put down a towel or small cloth to catch any coffee
that may still be in the line or bowl during removal.
C. Grasp the bowl and rotate counterclockwise to
loosen and remove the bowl.
Strainer
Gasket
Bowl
NOTE: The strainer is a metal mesh ring that will be located
inside the bowl. Also be careful not to damage the rubber
gasket that is seated in the bowl.
D. Visually inspect the clear strainer bowl for debris
and coffee grinds.
E. Rinse under tap water, scrub thoroughly inside and
out with the tube brush included with the unit.
F. Clean and sanitize before putting back into place.
G. Reassemble the bowl with mesh and gasket back in place.
H. Rotate bowl clockwise and hand tighten.
I. Reconnect the keg and check for leaks.
Imprtant
Strainer should be cleaned at minimum once a day.