MultiOne SRL
Self-moving Compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 6 Series
Instruction manual (Translation of the original instructions)
CM150032EN - 16.06.15 - 05 (11.07.18)
60
/76
9.8.6
Hydraulic oil filter change
To change the hydraulic oil proceed as follows:
1) Raise the loader arm.
2) Turn off the machine and secure the arm in the upright position with the safety block (see par. 9.3).
3) Remove the front panel by loosening the screws that secure it to the frame (see FIG. 39).
4) Remove the filter cover by rotating the cover. It may be necessary to use a wrench to loosen the cover (FIG. 39 - Ref. 1).
5) Remove the spring (FIG. 39 - Ref. 4), and the filter element (FIG. 39 - Ref. 5) from the plastic sleeve (FIG. 39 - Ref. 6).
6) Replace the filter element with a new original part.
7) Reinstall the spring and inspect the filter cover O-ring for any signs of wear or damage. This O-ring is located in a groove at the
top of the filter body (FIG. 39 - Ref. 3). Replace the O-ring in case of wear or damage.
8) Reinstall the filter cover (FIG. 39 - Ref. 2) and secure it.
9) Check the hydraulic oil level and, if needed, proceed to refill (see par. 9.8.5).
10) Reinstall the front panel.
ATTENTION
THE USED FILTER MUST BE DISPOSED OF IN ACCORDANCE TO THE LAWS IN FORCE IN THE COUNTRY WHERE THE MACHINE
IS USED.
FIG. 39
2
3
4
5
6
1
9.8.7
Hydraulic oil change
To change the hydraulic oil filter proceed as follows:
1) Raise the loader arm.
2) Turn off the machine and secure the arm in the upright position with the safety block (see par. 9.3).
3) Place under the hydraulic oil tank a suitable sized container with a capacity of at least 50 l.
4) Remove the hydraulic tank drain plug (FIG. 40 - Ref. 1), located under the machine near the right front wheel, and drain all
hydraulic oil from the machine into the container.
5) When all of the hydraulic fluid has drained out of the tank, reinstall and secure the drain plug. Make sure to inspect the drain plug
O-ring (FIG. 40 - Ref. 2) for signs of wear or damage. Replace the O-ring if any signs of damage are noted.
6) Change the oil filter (see par. 9.8.6).
7) Remove the cap of hydraulic oil tank (see par. 9.8.5).
8) Refill the hydraulic oil tank with recommended hydraulic oil - 0280 PAKELO HYDRAULIC EP AL ISO 46.
9) Check the hydraulic oil level (see par. 9.8.6).
10) Turn on the machine (see par. 8.3.2) for a few of minutes, in this way the oil flows inside the circuit oil.
11) Turn off the machine (see par. 8.3.6).
9- MAINTENANCE
Summary of Contents for 6 Series
Page 2: ......
