Seite 17 von 24
1.8.2 Installing the drag knife
1.
Remove the aluminum plunger from the plastic knife holder (5) by turning
the knurled adjustment knob (3) counterclockwise until the plunger comes out of
the holder.
2.
Insert the conical, non-cutting end of the knife into the opening in the narrow
end of the holder; gently push the knife all the way in.
3.
Turn the holder upside down and tap it lightly on a solid surface to ensure
that the knife is completely inserted.
4.
Slowly turn the knurled knob clockwise until the tip of the blade extends the
distance required for the desired cutting media (t) as shown in figure below.
5.
Insert the knife holder into head clamp, seating it
firmly.
6. Close the clamp and tighten the clamp screw.
FIG 1-23 KNIFE LENGTH
ADJUSTMENT
FIG 1-24 CLAMP
DRAG HEAD