Visit
for new product releases!
INST
ALL
ATION
Cop
yrigh
t © 2019 Multilink I
nc
. A
ll righ
ts r
eser
ved • Sp
ecific
ations subjec
t t
o change without notic
e • Re
v. 11/20/2019 •
Page 12
Do
cu
men
t N
o.
O
pti
ma
16
Ins
tal
la
tio
n G
ui
de
4.24 Pigtail Fiber Routing
Route the remaining slack of the fiber
pigtail around the inside perimeter of the Optima
16 hinged shell. Place the slack under the fiber
management clips to hold in place temporary.
4.27 Sealing the Gap
Insert any additional grommets that are
being used for the installation in the two open
available locations. Prior to isntallation, use sealant
to lubricate the outer edge of the grommet
for a proper seal. In this case, we will use blank
grommets to seal up the opening. Ensure the
grommets are inserted into the base in the correct
orientation following the gasket over mold pattern.
4.25 Fiber Management
Using the supplied tie-wraps inserted into
each fiber management clip on the Optima 16
shell tighten down enough to hold in place but not
directly damage the fiber.
4.26 Bulkhead Adapter(s) & Connector(s)
Remove the adapter cover and plug-in the
pigtail connectors following the universal fiber
color chart. DO NOT remove all the adapter covers
at once.
(Multilink is not responsible for any fiber loss
that may occur if this is performed improperly.)
Installation (Cont.)
