multilaneinc.com
Below is a brief guide on how to install the USB Driver:
-
Power up the board
-
Connect the board to the PC through USB cable
-
Download the USB driver file
-
Go to “Device Manager”
-
Find the target device that need to install the driver
-
Right-click on the device and select Update Driver Software
-
Select Browse my computer for driver software
-
Browse you PC and select the driver file
-
Click Next and wait until the driver is installed
4.2
GUI
For GUI installation and operation, refer to the link below. GUI user manual is available for
detailed description.
https://multilaneinc.com/products/ml4062-cnt/
5.
Hardware Revision
-
ML4062-Controller-RevA:
Initial Version
-
ML4062-Controller-RevB:
o
Add capacitor at the current sense output
o
Fix the issue of the power switcher connection
6.
Firmware Revision
-
ML4062Controller_V1.3
: latest FW revision, compatible with the ML4062-CNT-GEN2
RevB hardware.
7.
Bootloader
Accessing in bootloader mode allows the user to reprogram the microcontroller, this is done as
described below:
1. Connect a jumper on (J1) situated close to the microcontroller.
2. Connect a USB cable between the PC and Board.
3. Power up the board with a +3.3V supply.
4. LEDs (D1, D2) start blinking.
5. Remove jumper.
6. Open the software “Microchip USB HID Bootloader v2.3”.
7. Click on “Open Hex File”.
8. Choose the new FW to download.
9. Click on “Program/Verify”.
10. Once the software finishes programming press on “Reset Device”.
11. After reset the Firmware is successfully updated.
