User Manual
50
The operations of all control rotary controls are as follows:
The
Vertical Scale
and the
Vertical Position
rotary controls of Channel 1 are
used to set the horizontal scale and position.
The
Vertical Scale
and the
Vertical Position
rotary controls
of Channel 2 are
used to set the vertical scale and position continuously.
The following functions can not work in the XY Format:
Reference or digital wave form
Cursor
Trigger control
FFT
Operation steps:
1.
Push the
Display
button.
2.
Select
XY Mode
in the bottom menu. Select
Enable
as
ON
in the right menu.
3.
To make the XY view full screen, select
Full Screen
as
ON
in the right menu.
Counter
It is a 6-digit single-channel counter. The counter can only measure the frequency of
the triggering channel. The frequency range is from 2Hz to the full bandwidth. Only if
the measured channel is in
Edge
mode of
Single
trigger type, the counter can be
enabled. The counter is displayed at the bottom of the screen.
Operation steps:
1.
Push
Trigger Menu
button, set the trigger type to
Single
, set the trigger mode to
Edge
, select the signal source.
2.
Push the
Display
button.
3.
Select
Counter
as
ON
or
OFF
in the bottom menu.
How to Save and Recall a Waveform
Push the
Save
button, you can save the waveforms, configures, screen images, record
or clone the waveform.
The description of the
Save Function Menu
is shown as the following table:
