FS
2
Innovation. Quality. Performance. Best in Industry. Worldwide.
Fast Start Laser
1.
Turn on Power
Locate both power switches: the round knob located on the control enclosure and the power switch on the
operator’s console.
Rotate both to the ON position. The machine will not operate if one of the power switches is OFF.
2.
Turn on Air Pressure
Use the knob to adjust the air pressure.
Verify the pressure is between 80 and 100 psi.
3.
Open Gas Bottles
Turn the valve fully counter-clockwise (fully open) if used.
Verify the pressure is adequate for machines with capacitive height systems that cut ferrous metals and
machines with no capacitive height systems that cut non-ferrous metals.
4.
Turn on Laser
Rotate knob to the ON position.
Verify the chiller is turned on. The laser will not work without the chiller being on.
5.
Find Machine Hard Home
Press
Shift
and
Go Home
to find the hard home 0,0 or the machine home by indexing the gantry,
carriage, and Z assembly off of the proximity limit switches.
6.
Set Home
Press
Jog Arrows
to place the
center of the head assembly
over the front right corner
of the material.
Press
Jog Speed
to set the speed of the movement to slow, medium, or fast as necessary for the project
and material.
Press
Set Home
to set the home location for the head assembly. The system will prompt the operator as
to whether the selected position should be set as home, and the display will read “Press Down to set Rotation
Point.” See Rotate File for a description of this function.
Press
Enter
to confirm the position.
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com v. 11 10
