Multi-Tech MultiConnect mDot MTDOT Series, Developer'S Manual

Page: 11 / 69

GETTING STARTED
MultiConnect
®
mDot
TM
MTDOT Developer Guide for Japan 11
Chapter 2 – Getting Started
Getting started depends on what you want to do. By default, mDot ships with firmware that supports AT
Commands that use the serial I/O. For AT Commands, refer to the separate
mDot AT Command Reference Guide .
To send commands to the mDot:
1. Mount the mDot on the developer board. For details, refer to Installing an mDot on the Developer Board
2. Open communications software, such as HyperTerminal or TeraTerm.
3. Set the following:
Baud rate = 115,200
Data bits = 8
Parity = N
Stop bits = 1
Flow control = Off
Two serial interfaces are available through the USB interface, one is used to program the mDot and the other is for
debug messages. Refer to
mDot Pinout Design Notes for information on which pins are available out of the box.
To develop using mbed, the mDot mbed page includes libraries and test cases. Refer to mBed Documentation for
details and links.
For help setting up a Conduit
®
to send data to and from an mDot, refer to Related Documentation .